IntroductionTo the owner or user: This product manual is asource of information about the installation, startup, cleaning, maintenance and repair of t
Specifications:Limitations:·Must meet the same limitations as the cuberinstalled on top of it:n550F. air minimum,n1000F. air maximum.·Must be installe
Installation: GeneralAfter the carton has been removed from thedispenser, the legs may be installed.Place flat portions of the carton on the floor beh
HD156May 2002Page 4Installation: Ice MachineCheck that gasket tape has been placed at theoutside edge of the dispenser top.There is no thermostat to i
Final Check List/Initial Start Up1. Check that electrical power has been supplied.2. Check that a drain, separate from the icemachine, insulated and m
CleaningGeneral Care and CleaningPeriodically inspect and clean the ice dispenser tokeep it operating at peak performance.Wash the outside of the disp
HD156May 2002Page 7Operational SchematicIce MachineIce ChuteGear MotorSinkDrain PanCondensate PanDrainStorage Bin
Service DiagnosisHD156May 2002Page 8PROBLEM POSSIBLE CAUSE PROBABLE FIXDoes not vend No ice Check ice machineNo power Check power supplyVend switch op
Removal and Replacement:Gear Motor1. Disconnect electrical power2. Locate key and remove sink.3. Trace wires from gearmotor to control box anddisconne
Comentários a estes Manuais